For some (unknown) reason, redrawing while in the update loop breaks the
update (this probably warrants a closer look).
As a quickfix to restore functionality, remove the unnecessary redraw
call and move it into the async codepath, where it is actually needed.
fixes#1001
Since the configparser library by default parses keys case insensitive
(all lowercase), certain mappings, especially in the pulseaudio modules,
could fail ("internal" pulseaudio device names are matched against
entries in the configuration).
fixes#992
A previous change accidentially changed the "pretty" device name mapping
to be required to be in lowercase (rather than the exact name of the
devices. Restore previous functionality.
fixes#989
mousewheel up and down events were initially not working on my bumblebee status bar. After verifying on the command line, it seems that wpctl set-volume command requires sink ID first and percentage change as the second arg.
steps to verify, assuming wireplumber is installed and sink ID is 32
```sh
wpctl set-volume 32 50%
```
will set the volume to 50%
```sh
wpctl set-volume 50% 32
```
will result in `Object '52' not found
Based on cpu2 module, but use `sensors -j` and some json path walking to
better parse CPU temp and fan speeds. The output of `sensors -u` can
contain many duplicates of the same sensor name, but from different
sensor device paths.
Signed-off-by: SuperQ <superq@gmail.com>
* with newer versions of pi-hole, it is not possible
anymore to use the password hash for the API authentication.
Instead, one needs to use the dedicated API token for that.
In order to stay backwards compatible, and not break existing
bumblebee_status setups, the 'pwhash' parameter is still supported
(in case someone runs an outdated pi-hole version).
* the new pi-hole API endpoints do not allow to access the summary
endpoint without an API token. So, therefore '&auth=<api token>' was
added.
